Bosch WGM-B-1X/2A1S-G34-V - Installation and Connection; Assembly and Mounting Requirements

12/46 Set-up and connection
BoschRexrothAG, RE51550-B/09.2019
4 Set-up and connection
DANGER
Electrical voltage!
Danger of electric shock
▶ De-energize the plant.
▶ The device may only be installed, maintained and commissioned by
instructed, expert personnel.
▶ The applicable safety regulations of the place of use must be observed.
DANGER
Toxic, corrosive gases / liquids!
Protect yourself from toxic, corrosive gases/liquids during all work. Wear
appropriate protective equipment.
CAUTION
Overpressure!
Protect the device from static and dynamic overpressures.
Provide suitable measures for prevention!
4.1 Assembly
Before installing the device, make sure that the plant is depressurized, otherwise
liquid may escape. If necessary, use a collecting container. The WGM is delivered
completely assembled and can be screwed into the pipeline with the thread. Make
sure that the sensor part is always completely surrounded
by the medium in order to display correct measured values.
DANGER
Electrical voltage!
Danger of electric shock
When connecting the devices, the maximum admissible voltages and
currents (see technical data) must be observed and the required wire
cross-sections and circuit breakers must be dimensioned accordingly.
When selecting the connecting cables, the maximum admissible operating
temperatures of the devices must also be observed.