14
Special programmes
limp. pelusas / fios (Fluff Clean)
The drum must be empty.
This programme is designed to clean the drying cycle of any fluff
deposits. The washer-dryer uses the flashing symbol l (Fluff removal
cycle) in the display panel to show that this programme must be run. The
electronic cycle counter is then automatically reset. The l (Fluff Clean)
symbol goes out after the programme starts.
To run the limp. pelusas / fios (Fluff Clean) programme, proceed as
follows:
Make sure that the drum is completely empty and close the door.
Set the programme selector to limp. pelusas / fios (Fluff Clean).
Press the A (Inicio/Pausa) button.
You can also run the limp. pelusas / fios (Fluff Clean) programme at any
time without prompting from the appliance.
'+0 (Rinse + Spin):
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to $ (Rinse stop) before starting the
programme → page15.
++ 0 (Empty + Spin):
Drain the rinsing water following a programme with $ (Rinse stop)
→ page15.
Turn the programme selector to ++0 (Empty + Spin).
Set the spin speed to $ (Rinse stop).
Press the A (Inicio/Pausa) button.
or
Drain and spin at the desired spin speed:
Turn the programme selector to ++0 (Empty + Spin).
Press the 0 (Spin) button repeatedly until the desired spin speed is
set.
Press the A (Inicio/Pausa) button.
To Next Page
Loading...
