Bosch WTD 12-3 AME 31 - Data Visualization Modes; Last 10 Failures for diagnostic purposes

Page 39 from 45 6 720 887 546 “SM FP_ErP LPP-MPP Europe 2018/05 en”
Sequence of
Parameters in P4
Comment
Value / Unit
Operation Data Menu
Temperature indication
Inlet water temperature
Temperature read by inlet
sensor
ºC or ºF
Temperature indication
Hot water temperature
Temperature read by outlet
sensor
ºC or ºF
Water flow indication
l/min
Indicates water flow measured
by the turbine (l/min)
Output power (%)
Indicates exact percentage as
complement to power bar
indicator
Temperature of air in room
sealed box
Temperature read by outlet
sensor
ºC or ºF
Table 19 – Visualization mode parameters with readings of sensors
until
Last 10 Failures for
diagnostic purposes
Failure 1 is last failure
occurred
Failure 2 occurred before
Failure1
Failure 3 occurred before
Failure2
Failure 4 occurred before
Failure3
Failure 5 occurred before
Failure4
Failure 6 occurred before
Failure5
Failure 7 occurred before
Failure6
Failure 8 occurred before
Failure7
Failure 9 occurred before
Failure8
Failure 10 occurred before
Failure9
Table 20 – Visualization of last 10 failures