Bosch WUU28T48 - Page 40

en Troubleshooting
40
Fault Cause and troubleshooting
"E:35 / -10" ▶ Call the after-sales service.
→"Customer Service", Page48
Voltage under-usage
symbol (double point).
The automatic voltage control system detects an un-
authorised voltage under-usage.
▶ No remedial action possible.
Note:If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
lights up. Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
lights up. The temperature is too high.
▶ Wait until the temperature has dropped.
▶
→"Cancelling the programme", Page31
Water level is too high.
▶ Select a suitable programme for draining.
→"Programmes", Page24
flashes. Door is not closed.
▶ Close the door.
Laundry is caught in the door.
▶ Remove any trapped laundry.
All other error codes. Malfunction
▶ Call the after-sales service.
→"Customer Service", Page48
"E:30/-20" Solenoid valve defective.
▶ Call the after-sales service.
→"Customer Service", Page48
Detergent dosage is too high.
▶ Reduce the amount of detergent for the next wash-
ing cycle with the same load.
Additional water is added.
▶ Do not add any extra water to the appliance while it
is operating.
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶ Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
▶ Check the circuit breaker in the fuse box.