Installation | 41
6 720 643 068 (2011/06)Copyright (optional information)
5.6 Mounting the appliance
B Remove packaging, observing all notes and symbols.
B On the rating plate, check the identification of the
target country and suitability for the gas type supplied
by the local gas utility company (Æ page 12).
Removing the cover
B Undo screws (step 1).
B Lift strap (step 2) and remove cover toward the front
(step 3).
Fig. 18 Remove the cover
Hanging the appliance
B Place flat gaskets on the connections of the hydraulic
bracket.
B Hang appliance on the mounting bracket.
B Tighten the union nuts on the pipe connections.
NOTICE: Residue, metal shavings, and
contaminants in the piping can damage the
appliance.
B Flush the piping thoroughly and completely
to remove all residue.
B Follow the instructions with respect to
water quality (Æ Chapter 5.1, page 35).
The cover is secured with two screws against
unintentional removal (electrical safety).
B Always keep the cover secured with these
screws.
1
2
3
6 720 641 933-96.1o
1
To Next Page
Loading...
