Bose LIFESTYLE 135 series II - Page 46

Care
and Maintenance
Sound quality
has
changed and speaker
array status indicator
is
blinking
orange (135
series
II
systems
only).
TV
does not respond to
remote commands
(135 series
II
systems
only)
Intermittent
bass
(135 series
II
systems
only)
Sound is impaired by
a
loud
hum or buzz,
which may be
electrical
in
nature
Radio does not work
FM
sound is distorted
Picture is
blurry
when
viewing
30
content
Sound is distorted
28-
English
Press the Setup button
on
the
control console
and
select
the
"Reconnect
Acoustimass" menu item.
Follow
the onscreen
instructions.
•
Make sure the speaker array is not
blocking the
IR
sensor on
the
TV.
Change the position of the
TV
and speaker array so
that the
I
R sensor is not
blocked.
•
For details
on the
location
of
the TV's I R sensor, refer to the
owner's guide that came with your
TV.
•
Check that the status indicator
on
the Acoustimass®
module
is
orange and not blinking.
• If
the speaker array status indicator is
blinking
orange:
- Check that the Acoustimass
module
is
plugged
into a
live
AC
wall outlet
and the status indicator is
glowing orange.
- Press the Setup button
on
the
control console
and
select
the
"Reconnect Acoustimass" menu item.
Follow
the
onscreen instructions.
-Try
moving any possible
sources
of
wireless
interference,
such as a
wireless
computer network
router, another
wireless
device, or a microwave oven, further away from
the system.
Contact
Bose®
Customer Service to determine if and how
other
electrical
devices
in
the room may be creating unwanted
signals,
and
to
obtain
possible
remedies.
•
Make sure antennas are connected properly.
• Move AM antenna at
least 20
inches
(50
em)
from the
control
console
and Acoustimass
module.
• Adjust antenna position to improve reception.
•
Make sure the AM antenna
is
in
an
upright position.
•
Move antennas farther from
control console,
TV,
or other
electronic equipment.
• Select
another station.
You
may be
in
an
area
of
weak signal
coverage for some stations.
•
Adjust antenna position to reduce interference.
• Fully
extend the
FM
antenna.
• If your
30
glasses
are
of
the active type, make sure they
are
turned on.
•
Try
changing the
30
system option to a different setting.
• If
the
problem
persists, make sure the speaker array
is
not
blocking
the
I R sensor on the
TV.
Change the position of the
TV
and speaker array so that the
I R sensor is not
blocked.
•
For details
on the
location
of
the TV's
IR
sensor, refer to the
owner's guide that came with your
TV.
•
Make sure the audio input cable
is not damaged and the
connections are secure on both ends.
•
Reduce the volume
output
level
from any
external
devices
connected to the
control console.
•
(135 series
II
systems
only)
Remove the protective film
from
the trim and
grille
on the speaker array and the front of the
Acoustimass module.