Remote
control
maintenance
Changing the batteries as needed is the only regular maintenance required. However, the
switches inside the remote battery case may be changed, as needed. Additional remotes for
use
in
other rooms may need their switches changed, too. For that, refer to
'~Bose®
link
remote switch settings" on page 39.
Replacing
the
remote
control
batteries
Replace all four batteries when the remote control stops operating or its range seems
reduced. Alkaline batteries are recommended.
1. Slide open the battery compartment on the back
of
the remote (Figure 17).
2.
Insert four AAA or IEC-LR3 1.5V batteries, or the equivalent, as shown. Match the +
and - symbols on the batteries with the + and - markings inside the compartment.
3.
Slide the battery compartment cover back into place.
Figure
17
Installing the remote
control batteries
AAA batteries
(4)
~
Battery
compartment
Battery
compartment
cover
Changing house
code
settings
Each
L1FESTYLE®
remote control uses a house code that corresponds to the house code set
in
the media center, enabling the
two
to communicate. If another
LlFESTYLE®
system nearby
creates a conflict with your system, you can easily set a new house code
in
your media center
and its remote control(s) with steps that follow.
Using the remote control:
1.
Open the remote control battery cover and locate the miniature switches (Figure 18
on
page 38).
2.
Move one or more
of
switches
1,
2,
3,
or 4
in
the opposite direction from its current
setting. Use a paper clip, ball point pen,
or
similar object.
)
Note:
00
NOT change any other switch settings. Moving other switches may disable your
remote control.
3.
Replace the battery cover.
37
To Next Page
Loading...
