System Setup
D. Plug one end of the audio input cable into the control console connector
labeled Audio OUT. Make sure the flat surface with the arrow on the plug
faces up.
Leave the other end of the cable on the floor. You will be asked to connect it
while setting up the contents of the next box.
Audio OUT
E. Plug the power supply output cord into the control console Power connector.
Power
AC power cord
Power supply
Power supply
output cord
F. Remove a power cord from the power cord box.
G. Plug one end of the power cord into the power supply.
Make sure you push
the plug in as far as it can go.
H. Plug the other end of the power cord into a live AC (mains) power outlet.
I. Continue with Box
2
on the next page.
English - 9
To Next Page
Loading...
