28
DISASSEMBLY PROCEDURE
1. End Cap Removal
1.1 Remove the ten screws that secure the end
cap to the loudspeaker housing. Lift off the end
cap and gasket shown by arrows in fi gure 3.
1.2 Repeat step 1.1 to remove the end cap
and gasket at the opposite end of the MSA12X
housing shown in Figure 4.
2. Grille Removal
2.1 Perform procedure 1.
2.2 Carefully pull the grille assembly away from
the MSA12X housing.
Note: The grille is held in place with a butyl
rubber strip gasket material. If you damage the
butyl rubber stripping and cannot re-use it, you
can replace it with 3M butyl rubber stripping,
2mm width.
3. Logo Removal
3.1 The logo is adhered to the front of the grille.
Carefully lift off the logo shown in Figure 5.
Note: Be sure to replace the logo with a new one
instead of re-using the old one. The adhesive on
the old logo will not keep it in place after it has
been removed once.
3.2 The grille retainer is placed on each end as
shown in Figure 6.
Note: Place the grille retainers on the grille
edges prior to reattaching the grille to the
MSA12X enclosure.
Figure 3
Figure 4
Figure 5
Figure 6
To Next Page
Loading...
