29
DISASSEMBLY PROCEDURE
4. Driver Removal
4.1 Perform procedure 1.
4.2 Remove the four screws that secure the
driver to the front baffl e indicated by arrows in
Figure 7. Lift out the driver and disconnect the
two Faston connections of the wiring harness.
5. Driver Assembly Removal
5.1 Perform procedure 1.
5.2 Remove the 24 screws that secure the driver
assembly section to the MSA12X housing. Figure
8 shows the location of the screws. Take care to
not damage the gaskets. You will need to re-use
them.
Note: There are washers for each screw .Make
sure you take notice as the washer may not come
out with the screw.
5.3 Lay the MSA12X on it’s side. Gently pull
the outer edges of the driver assembly outward
slightly as shown in Figures 9 and 10.
Figure 7
Figure 8
Figure 9
To Next Page
Loading...
