SET UP PROCEDURES (Continued)
21. Install Dante Virtual Sound Card.
Note: You will need to purchase a license from
Audinate.com to activate and use the Dante Virtual
Sound Card as shown in fi gure 27. A license can
be purchased on a temporary basis or a permanent
basis. Audinate does not accept AMEX credit cards.
22. Insert an Ethernet cable to the PC, connect the
other end to the router using LAN port 1. Insure that
the router has AC power.
23. Connect a second Ethernet cable to LAN port
2 on the router and insert the opposite end of the
Ethernet cable to the Dante RJ45 connector located
on the MSA12X loudspeaker.
Note: Insure that you do not insert the RJ45 Ethernet
cable into the RJ50 connectors. The RJ50 connectors
are for an LVDS cable to supply audio to another
MSA12X loudspeaker.
24. Connect the analog Phoenix connector from the
signal generator with a signal of 500Hz, + 1Hz @ 20
mv to the MSA12X loudspeaker.
25. Connect the appropriate power cable to the
MSA12X loudspeaker and apply AC Main.
26. Activate the Dante Virtual Sound Card and click
on the Start Tab as indicated by a red arrow in fi gure
27.
Figure 27
Connections set up for Dante and Analog Testing
27. Open the Dante controller application and select
the device info tab, You will see two IP addresses as
shown in fi gure 28, one IP address is for the MSA12X
and the other IP address is for the computer as
shown in Figure 28.
28. The MSA12X is now considered a receiver and
the PC is now a transmitter.
Figure 28
36
To Next Page
Loading...
