34
FUNCTIONAL TEST PROCEDURES
7. Factory Default
It is important to reset the unit to its factory de-
fault setting. As the unit stores the last volume
setting, audio source selection and bluetooth
pairing history after testing. This is to prevent
customer receive test settings.
7.1 Use the remote to turn on the unit on.
7.2 Issue TAP command as below.
“UI NC” - Factory default for TV source
“BT CP” - Factory default for bluetooth
“VO [30, 50]” - Factory default for volume
and bass
7.3 Turn the unit off with the remote.
7.4 Remove power from the unit.
To Next Page
Loading...
