40
MANUFACTURING MODE COMMAND PROMPT SETUP
SoundTouch
®
10 Wi-Fi Music System
Manufacturing Mode Command Prompt Setup
Manufacturing Mode Command Prompt are
needed for the following procedures.
A. Set Variants
B. Set Country Code
C. Set Region Code
D. Set Serial Number
Equipment Required
Hardware
Thumb Drive
Computer with USB ports.
USB A to MICRO B cable P/N 743203-052210.
Micro usb to USB cable
Software
Window Command Prompt.
Bose
®
SoundTouch software.
Manufacturing “update.stu” le.
TeraTerm terminal emulator
(Download at http://sourceforge.jp/projects/
ttssh2/)
Manufacturing Mode Command Prompt
Please follow these instructions to setup your
SoundTouch 10 device into manufacturing mode.
1. Download Manufacturing “update.stu” into
a thumb drive from Bose
®
product’s repair
information page.
2. Insert thumb drive into unit’s USB port.
3. While connecting power to the unit, press
and hold preset 4 and volume minus.
4. Release buttons when all LEDs are light up.
5. Unit will reboot when completed the setup.
6. Once the SoundTouch 10 boot into manu-
facturing mode, Bluetooth, AUX and Shelby
LEDs will start blinking.
7. Download and install TeraTerm terminal em-
ulator from Bose repair information site.
8. Launch a Tera Term terminal window and
select serial communication and port as shown
below.
9. Press enter and now you have the Manu-
facturing Mode Command Prompt.
Figure 42. Tera Term, Port Selection
Figure 43. Tera Term, Prompt
To Next Page
Loading...
