35
SERIAL NUMBER AND COUNTRY CODE PROGRAMING
Perform both of these procedures any time
the Wi-Fi Module is replaced.
Download two macros from the Sound-
Touch™ product’s repair information page
located on http://serviceops.bose.com. Place
these macros in the Tera Term program
folder.
set_serial_number.ttl
set_country_code.ttl
1. Setting the Serial Number
1.1 Connect the SoundTouch to a computer
as shown in the TAP command set up proce-
dure on pages 24 and 25.
1.2 Within Tera Term, select Control then
Macro and Select the file -
“set_serial_number.ttl”
1.3 Follow the prompts.
Note: The serial number can be read by
pressing the Volume - button and the number
5 at the same time for 5 seconds for system
information. Use the Volume - and + button to
toggle through system information.
2. Setting the Country Code
2.1 Connect the SoundTouch Portable to a
computer as shown in the TAP command
set up procedure on pages 30 and 31.
2.2 Within Tera Term, select Control then
Macro and Select the file -
“set_country_code.ttl”
2.4 Follow the prompts.
Note: Selecting us sets the Wi-Fi module to
the US standard channels 1-11. Selecting eu
sets the Wi-Fi module to EU standard
channels 1-13
3. Reading the Country Code.
3.1 Type the command “local_services on”
and <enter>. Then press CTRL-C on the
keyboard. Then type “e” and <enter>. The
command line
mojo login: should be dis-
played on the computer.
3.2 Type the command “root” and <enter>.
The command line should be
root@mojo:root#.
3.3 Enter “cat /var/tmp/mfgdata.xml”. The
country code is displayed in the first line of
the response.
3.4 Return to CLI prompt by entering the
command “rm /mnt/nv/local_services” and
<enter>.
3.5 Enter the command “exit” and <enter>.
This will return to the TAP interface (CLI) and
a TAP command line “->” should be shown.
To Next Page
Loading...
