38
BACK DOOR KEY PRESSES
1. System Information
1.1 Press and hold the Volume (-) minus and
Preset 5 to bring up System Information. Use
the Volume (-) minus and plus to toggle
through the items.
1. MAC address
1.1 Ethernet MAC address
1.2 Wi-Fi MAC address
2. Network Information
2.1 Connection Type
2.2 IP Address
2.3 SSID
2.4 RSSI (Received Signal Strength),
rates Wi-Fi signal received strength
3. SoundTouch™ Information
3.1 Component ID
3.2 System Serial number
3.3 Component ID (Wi-Fi)
3.4 Wi-Fi module Serial Number
3.5 DSP Firmware
4. SoundTouch Information
4.1 Wi-Fi module Serial Number
4.2 Wi-Fi module Firmware
5. SoundTouch Controller Information
5.1 Connected
2. Factory Default
2. Press and hold the Volume (-) minus and
Preset 1. The system will return to factory
default settings and reboot.
3. Software Update
3.1 Press and hold the Volume (-) minus and
Preset 4 to initiate a software update.
3.1.1 The unit will download software from
the update over Wi-Fi.
3.1.2 While applying power and holding the
Volume minus and Preset 4 button, the
unit will load software from a thumbdrive
inserted in its USB port.
4. Alternate Setup (connect unit to Wi-Fi
network)
4.1 Press and hold the Volume (-) minus and
Preset 2 to initiate alternate setup mode.
4.2 Connect a smartphone to the unit’s
Bose
®
Soundtouch Wi-Fi network.
4.3 The units Wi-Fi setup page IP address
will be shown on the unit’s display. Enter the
IP address into smart phone browser and
follow the directions on the page.
5. Disable/Enable Networking
5.1 Press and hold the Volume (-) minus and
Preset 3 to enable or disable networking.
To Next Page
Loading...
