1.
Read
these
instructions - for all components
before using this product.
2.
Keep
these
instructions-
for future reference.
3.
Heed
all
warnings - on the product and in the
owner's guide.
4.
Follow all
instructions.
5.
Do not use
this
apparatus
near
water
or
moisture - Do not use this product near a bathtub,
washbowl,
kitchen sink,
laundry
tub,
in
a wet
basement, near a swimming
pool,
or anywhere
else
that water
or
moisture are present.
6.
Clean only
with
a
dry
cloth-
and as directed by
Bose Corporation.
Unplug
this product from the
wall
outlet
before
cleaning.
7.
Do not block any ventilation openings.
Install
in accordance with
the
manufacturer's
instructions-
To
ensure
reliable
operation
of
the
product and
to
protect it from overheating, put the
product
in
a position and
location
that will
not
interfere with its proper
ventilation.
For
example,
do
not
place
the product on a bed, sofa,
or
similar
surface that may block
the ventilation
openings. Do
not put it
in
a
built-in
system, such as a bookcase or
a cabinet that may keep air from
flowing
through its
ventilation
openings.
8.
Do not install
near
any
heat
sources, such as
radiators,
heat
registers, stoves
or
other
apparatus (including amplifiers)
that
produce
heat.
9.
Do not
defeat
the
safety purpose
of
the
polarized
or
grounding-type plug. A polarized
plug has
two
blades with
one
wider
than
the
other. A grounding-type plug has
two
blades
and a third grounding prong.
The
wider
blade
or
third prong
are
provided
for
your safety.
If
the
provided plug does
not
fit
in your outlet,
consult an electrician for replacement
of
the
obsolete
outlet.
10.
Protect
the
power
cord from being
walked
on
or pinched, particularly
at
plugs, convenience
receptacles, and
the
point
where
they
exit
from
the
apparatus.
11.
Only
use attachments/accessories specified
by
the
manufacturer.
12.
Use
only
with
the
cart,
stand,
<I
tripod,
bracket
or
table
specified by
the
manufacturer
or
sold
with
the
•
apparatus.
When
a
cart
is used, use
caution
when
moving
the
cart/
apparatus combination
to
avoid injury from
tip-over.
IMPORTANT
SAFETY
INSTRUCTIONS
13.
Unplug this apparatus during lightning storms
or
when unused
for
long periods of
time
-
to
prevent damage
to
this product.
14. Refer all
servicing
to
qualified service
personnel. Servicing is required
when
the
apparatus has been damaged in any way: such
as
power-supply cord
or
plug is damaged;
liquid has been spilled
or
objects have
fallen
into
the
apparatus;
the
apparatus has been
exposed
to
rain
or
moisture, does not
operate
normally,
or
has been dropped - Do not attempt
to
service this product
yourself.
Opening or
removing covers may expose you
to
dangerous
voltages
or
other hazards.
Please call
Bose
to
be
referred
to
an authorized service center near you.
15.
To
prevent risk
of
fire
or
electric shock, avoid
overloading
wall
outlets, extension cords, or
integral convenience receptacles.
16.
Do not
let
objects
or
liquids
enter
the
product
- as they may touch dangerous
voltage points
or
short-out parts that
could result
in
a fire or
electric
shock.
17.
See
product enclosure bottom for safety
related markings.
18.
Use Proper
Power
Sources -
Plug
the product
into a proper power source,
as
described
in
the
operating instructions
or
as marked on the product.
19. Avoid
Power
Lines - Use extreme care when
installing
an
outside antenna system
to
keep from
touching power
lines
or
circuits, as contact with
them may be
fatal.
Do
not
install external
antennas
near overhead power
lines
or other
electric light or
power circuits, nor where
an
antenna can
fall
into
such circuits
or
power
lines.
20.
Ground All
Outdoor
Antennas -
If
an
external
antenna
or
cable
system
is
connected to this
product, be sure the antenna or
cable
system is
grounded. This
will provide some protection against
voltage
surges and built-up
static charges.
Section
810
of
the National Electrical Code ANSI/
NFPA
No.
70
provides information with respect
to
proper grounding
of
the mast and supporting
structure, grounding of the lead-in
wire
to
an
antenna discharge unit, size
of
grounding
conductors,
location
of
antenna-discharge unit,
connection
to
grounding
electrodes,
and
requirements for the ground
electrode.
Refer to the
antenna grounding illustration
on the next page.
English - 3
To Next Page
Loading...
Need help?
General
