Boss GT-10 Training Guide

BOSS GT-10 Training Guide
If you have one guitar amp without an effect loop:
1. Plug the MONO Output into the CLEAN channel of the amp.
2. Set the amp for a clean sound with flat EQ
2. Set the Correct Output Setting
After connecting the GT-10 to amps:
1. Press the OUTPUT SELECT BUTTON
2. Turn the PATCH/VALUE DIAL to select LINE/PHONES.
3. Connect a guitar to the INPUT on the back of the GT-10.

Boss GT-10 Specifications

General

Type	Multi-Effects Processor
Amp Modeling	Yes
D/A Conversion	24-bit
Sampling Frequency	44.1 kHz
Expression Pedal	Yes, built-in
Outputs	2 x 1/4" (L/Mono, R)
MIDI I/O	In, Out
A/D Conversion	24-bit
Effects Types	Overdrive, Distortion, Delay, Reverb, Modulation