Boss GT-10 Training Guide

BOSS GT-10 Training Guide
The Quick Demo: Show Amp & Effect Switching by CTL pedal 1
and Loop Recording
1. Rotate the PATCH/VALUE DIAL to select Patch p29-3: TONE JOURNEY
Or
Press the BANK UP/DOWN pedals to select Bank 29.
2. Press NUMBER PEDAL 3 to select Patch p29-3: TONE JOURNEY
3. Start playing and you will hear a slightly distorted tone with Delay and Reverb.
Press the CTL 1 pedal; this will switch Amp models, and Delay type; you will also
activate the Chorus and the Compressor.
4. You can also “tap” in the delay time by stepping on the CTL 2 pedal.

Boss GT-10 Specifications

General

Type	Multi-Effects Processor
Amp Modeling	Yes
D/A Conversion	24-bit
Sampling Frequency	44.1 kHz
Expression Pedal	Yes, built-in
Outputs	2 x 1/4" (L/Mono, R)
MIDI I/O	In, Out
A/D Conversion	24-bit
Effects Types	Overdrive, Distortion, Delay, Reverb, Modulation