46 User Manual Edition 04/10
BP-PR PLUS Series
6-1-2 Copying New Firmware from Memory Card
1. Format CompactFlash memory card in printer (see 8-2 Formatting on page 51.).
The directories "fonts", "images", "labels" and "misc" are created on the memory
card here.
2. Copy the firmware file to the "misc" directory in a CompactFlash drive.
3. Insert the prepared memory card into the printer.
4. Press the menu button.
5. Select Service > Firmw. fr. card menu.
6. Press the button.
7. If the function Firmw. fr. card is protected via a PIN, use the buttons
, , and to enter the code number and confirm with the button.
The names of the firmware files found on the memory card are shown in the
display.
8. If several firmware files are found on the memory card, select the desired file with
the and buttons.
9. Press the button. The selected firmware file is copied. A progress indicator is
displayed while the firmware is being copied. OK appears in the display once
copying is successfully completed.
10. Press the button.
6-1-3 Error Messages during the Firmware Update
If an error occurs during the update, one of the following error codes is shown in the
display:
Table 19. Possible Error Codes with a Firmware Update
Error code Meaning
C
Checksum error. /b may have been forgotten in the COPY command or the file is
defective.
H
Header error. /b may have been forgotten in the COPY command or the file is
defective.
E
EPROM could not be cleared.
V
Programming voltage is too low.
P
Programming error.
i
If an error occurs with a firmware update, the old firmware version is no longer
usable. Restart programming in this case.
To Next Page
Loading...
Need help?
General
