To Next PageTo Next Page
Need help?Do you have a question about the Brainstorm X-Glider and is the answer not in the manual?
Push in Wing Tip (Blue) and secure pocket (left/right).
Slide the Lower Wing opening under the Wing Arm (Green).
Slide main wing under Connector (Yellow) then into Pocket (Black).
Fold over and secure the Wing Strap (Red).
Push and Snap-in the Lower Wing Arm into Body Plate (left/right).
Secure Body Tab to Tail Rod.
Insert Spreader into Tail Connector (Orange).
Align 3 Pegs (Red) between each opening of the Tail Wing, then insert.
Align 3 Pegs (Purple) between each opening of the Tail Wing, then insert.
Position index finger behind body for throwing position.
Arm movement should follow through pointing with the index finger.
Aim glider slightly above Level Line to have better flight range.
Based on flying conditions you can adjust weights to your liking.
Align Tuning Weights (Green) opening to rod then snap into place.
Double Check Assembly. Each connector arm must be aligned each Tail Wing as shown.
Double Check Wing Tension. If glider flies left then adjust left wing. If glider flies right then adjust right wing.
If glider nose dives towards the ground, then the tail is too light.
Add Tuning Weights 1 piece at a time till desired results or position all weights to the end of the glider.
If glider flies up and stalls in the air, then the tail is too heavy.
Remove Tuning Weights 1 piece at a time till desired results.
General| Brand | Brainstorm |
|---|---|
| Model | X-Glider |
| Category | Toy |
| Language | English |
