www.bramblecrest.com/instructions
3.
Remove drawer.
Gently manoeuvre switch plate into position (ensuring plate/external holes line up).
Push part ‘C’ through 4 x external holes.
Fasten part ‘D’ to the end of part ‘C’ from inside the table.
Tighten all screws.
4.
Gently place gas cylinder on shelf.
Attach the regulator to the gas cylinder ensuring tap is in the closed position.
When fitting the hose make sure that it is free from twists, kinks or sharp bends.
Do not allow the hose to touch any hot surface or sharp edges.
To Next Page
Loading...