BrandMotion 9002-8847 User Manual

INSTALLATION INSTRUCTIONS
Jeep Wrangler Adjustable Rear Vision System for Factory Display Radios,
2007 – 2018 JK (Kit # 9002-8847)
Items Included in the Kit
Camera
Chassis Harness
Power Harness
22--pin white connector w/ video RCA (for factory
display radio)
Program Module
Zip lock bag with 15 Wire Ties & 3 Push Nuts
Camera Extension Bracket
These Instructions
Required Tools & Supplies
T15 & T20 Torx Bits
7mm & 10mm Sockets
Phillips Screwdriver
3/8” Wrench or Socket Drive
Plastic Trim Removal Tool
Soldering Iron, Solder, & Heat Shrink Tubing
(RECOMMENDED) or T-taps as an alternate
splicing method
Electrical Tape
Please read so you do not VOID the
warranty:
If the camera harness is run through the center on the camera bracket, it
will cut the camera harness. This will void the warranty on the camera.
9002-8847 Instructions 6-10-19.docx Page 1 of 7 KB

BrandMotion 9002-8847 Specifications

General

Waterproof	Yes
Compatibility	Universal
Material	Plastic
Color	Black
Weight	0.5 lbs

Summary

Install Camera

Step 1: Loosen lug nuts to remove spare tire

Loosen lug nuts on the spare tire to allow for its removal.

Step 2: Slide Camera on studs

Slide the camera onto the studs, routing the harness end inside the tire carrier.

Step 4: Remove spare tire and slide push nuts

Remove the spare tire and install the three supplied push nuts onto the studs.

Install Chassis Harness

Step 6: Insert camera connector through rear gate vent

Route the camera connector through the rear gate vent behind the tire carrier.

Step 7: Remove interior panels on inside of rear gate

Step 8: Pull harness through rear gate openings

Step 9: Secure Chassis Harness to existing harness

Step 10: Secure Chassis Harness to existing harness

Running Chassis Harness Forward

Step 12: Remove subwoofer box

Step 16: Pull back carpet and run harness

Step 17: Run Harness under B-pillar cover

Route harness under B-pillar cover to passenger door sill, removing sill plate.

Connecting Power and Radio

Step 25: Remove center stack/cluster surround

Step 26: Remove glove box and run Mirror Harness

Step 28: Connecting Power

Splice power and ground wires for the camera system.

Step 29: Plug Chassis Harness RCA connector

Connect the Chassis Harness RCA connector to the provided jumper harness.

Step 30: Insert white 22-pin connector into radio

Insert the white 22-pin connector into the back of the factory radio.

Programming and Testing

Programming Instructions

Instructions for programming the VIN-locked module.

Step 31: Test the system

Test the system by starting the vehicle and shifting into reverse.

Step 32: Reassemble vehicle

Camera Settings: Parklines and Mirror Image