Need help?Do you have a question about the Bras Is-Cream and is the answer not in the manual?
General| Brand | Bras |
|---|---|
| Model | Is-Cream |
| Category | Ice Cream Maker |
| Language | English |
Ensure correct voltage, single-phase, earthed socket, and category III overload protection.
Do not use extension cables to connect the appliance.
Damaged power cables must be replaced by qualified personnel.
The dispenser is not suitable for outdoor use.
The dispenser must be installed in the upright position.
Always disconnect before cleaning or maintenance.
Do not use a water jet for cleaning.
Appliance must not be operated or played with by children.
Use by persons with reduced capabilities requires supervision or training.
Only trained persons may access inner components for safety.
Appliance is for domestic and similar use only.
Room temperature must be between +5°C and +32°C for correct operation.
Use only for indicated liquids; do not use dangerous or toxic liquids.
Details bowl and evaporator capacity.
Lists width, depth, and height of the dispenser.
Provides net/gross weight, compressor, and condenser details.
Covers overload protector, noise level, and electrical characteristics.
Remove from packaging and check for transport damage.
Position on a stable counter with adequate clearance for airflow.
Check stability and adjust feet height if necessary.
Read manual and ensure the appliance is correctly earthed.
Operate only with panels and cover in place and secured.
Do not insert fingers or objects into panel slits or tap orifice.
Always disconnect from electricity before removing parts or panels.
The cover must remain closed at all times during operation.
Assemble the mixing pipe and pour mixture into the upper tank.
Close cover, turn on, and adjust mixing pipe for air quantity.
Dispense ice cream and adjust density settings.
Understand the continuous operation and cooling system cycles.
Select ICE CREAM PRODUCTION, CONSERVATION, or WASHING modes.
Details the main switch and the ON/OFF key for power control.
Overview of touch display icons and indicators for status.
How to adjust the ice cream density via the touch display.
Ensure proper heat dissipation and clear surroundings for optimal performance.
Appliance is intended for confectionery products only.
Steps for cleaning preparation and disassembling the dispenser.
Detailed procedure for washing all parts and rinsing them.
Instructions for sanitizing components after washing.
Step-by-step guide to reassemble the dispenser.
Procedure for sanitizing the assembled appliance before operation.
Check for product leaks from the tap assembly seal.
Inspect scraper coupling seal and check for leaks.
Clean dust from the condenser filter.
Warnings regarding condenser fins, noises, breakdowns, and repair work.
To Next Page
