Page 3For technical questions, please call 1-888-866-5797.Item 59224
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Charging the Battery
Note: Before using light for the first
time, fully charge the battery.
1. Open the Charge Port Cover using a suitable tool.
2. Plug one end of USB adapter into Charging
Jack. Plug other end to a 5VDC 2A source.
3. When all 4 LED charge lights turn
blue, the Battery is fully charged.
4. Disconnect the USB Cable.
5. Close the Charge Port Cover
6. To maintain waterproof seal, use
a suitable tool to tighten screw on
Charge Port Cover. Do not overtighten.
Charging Jack
LED Charge
Lights
NOTICE: Do not leave the Battery in a discharged
state. Charge the Battery every 3 months if the
Spotlight isn’t in use. This will keep the Battery
from wearing down and add to its life.
General Operating Instructions
1. Hold the Spotlight using the Hand Grip.
2. Move the Lock Switch UP to unlock it and then
turn ON the Spotlight by squeezing the Trigger.
3. Select the desired light output using the Trigger:
One press for low beam, two for medium beam,
three for high beam, four for SOS and five for
strobe. The sixth press turns the light OFF.
4. Use the Lock Switch to lock the light on or
off. When the Lock Switch is moved DOWN,
the Trigger is locked in its last setting.
Note: The Spotlight can sit on its
back and can float in water.
Note: The Spotlight’s Stand / Hanger can be adjusted,
extended and positioned as desired or hung.
Stand / Hanger
5. When finished using the Spotlight, turn it OFF
and lock Trigger to prevent accidental operation.
6. After use, wipe Spotlight with a clean soft cloth
and store indoors out of children’s reach.
To Next Page
Loading...
