Braun 9295cc - Performance Degradation and Damp Head; Troubleshooting Clean&Charge Station; Station Cleaning Start Issues

14
Shaving
performance
dropped
significantly.
1. Shaving system is
clogged.
2. Foil and cutter are worn.
1. Soak the Foil & Cutter cassette in
hot water with a drop of dish liquid.
Afterwards rinse it properly and tap
it out. Once dry apply a drop of light
machine oil on the foil.
2. Replace Foil & Cutter cassette.
Shaver turns
off with fully
charged
battery.
Foil and cutter are worn
which requires more power
than the motor can deliver.
The appliance turns off.
– Replace Foil & Cutter cassette.
– Regularly oil the shaving system,
especially when cleaning with water
only.
Shaver head is
damp.
1. Drain of the Clean&Charge
Station is clogged.
2. Cleaning cartridge has
been used for quite a
while.
1. Clean the drain with a wooden
toothpick.
2. The alcohol proportion has
decreased while the oil proportion
has increased. Remove residue
with a cloth.
CLEAN&CHARGE STATION
Cleaning does
not start when
pressing the
start button.
1. Shaver is not placed
properly in the
Clean&Charge Station.
2. Cleaning cartridge does
not contain enough
cleaning fluid (level
indicator blinks red).
3. Appliance is in stand-by
mode.
1. Insert shaver into the Clean&Charge
Station (contacts of the shaver
need to align with contacts in the
station).
2. Insert new cleaning cartridge.
3. Press start button again.
Increased
consumption of
cleaning fluid.
Drain of the Clean&Charge
Station is clogged.
– Clean the drain with a wooden
toothpick.
– Regularly wipe the tub clean.
90892135_Series_9-2_NA_S6-48.indd 1490892135_Series_9-2_NA_S6-48.indd 14 27.05.16 10:1427.05.16 10:14
CSS APPROVED Effective Date 30May2016 GMT - Printed 29Jun2016 Page 14 of 48