7
• Hold the distance comb with the angled edge against your beard and
guide the trimmer against the direction of hair growth.
• To avoid clogging the distance comb with hair, clean it from time to time
with the brush. Please note that the distance comb can only be taken off,
when the trimmer is turned off.
C Hair cutting
• The hair should be clean, well combed, tangle-free and dry.
• Proceed as described under (B), but using the larger distance comb
(settings approx. 10 / 12 / 15 / 18 / 21 / 25 mm). If you are not used to
clipping hair, begin with a higher setting and then reduce the setting to
avoid cutting more hair than desired. If you want to cut your hair shorter
than 10 mm, we advise to first cut it with the larger distance comb down
to 10 mm and then use the smaller distance comb for the desired length.
• Use a slow and controlled movement. Do not force the appliance through
the hair faster than it can be cut.
• In between, shake or blow off the hair. If too much hair is caught in the
distance comb, remove and clean it. Please note that the distance comb
can only be taken off, when the trimmer is turned off (position «0»).
Keeping your trimmer in top shape
D Cleaning and care
• After each use, take off the distance comb and slightly shake or brush
hair from the beard trimmer and the distance comb.
• Press the release buttons (2b) to lift off the cutter system. Using the
brush, clean the cutter system and the inside of the trimmer.
• Then click the cutter system back to original position by pushing forward.
Subject to change without notice.
At the end of their life, empty batteries and the appliance should not
be thrown away with general waste or rubbish. Please dispose of
them at a Braun Service Centre or at an appropriate local collection
point.
99354538_EP15_MN Seite 7 Mittwoch, 6. Januar 2010 1:23 13
To Next Page
Loading...
Need help?
General
