7
• Switch the shaver on (cordless) and rinse
the shaving head under hot running water.
A natural based soap may also be used
provided it contains no particles or abrasive
substances. Rinse off all foam and let the
shaver run for a few more seconds.
• Next switch the shaver off and press the
release buttons. Lift the shaver foil off and
pull the cutter block out. Then leave the
disassembled shaving parts to dry.
Alternatively, you may clean the shaver using
the brush provided:
• Switch the shaver off. Press the release
buttons and lift shaver foil off.
• Using the brush, clean the cutter block and
the inner area of the shaver head. However,
do not clean the shaver foil with the brush as
this may damage the foil.
• Clean the charging stand with a damp cloth.
Unplug first.
Keeping your shaver in top
shape
About every four weeks, clean the cutter block
with Braun cleaning agents. Put a drop of light
machine oil onto the long hair trimmer and the
shaver foil.
Preserving the batteries
In order to maintain the optimum capacity of
the rechargeable batteries, the shaver has to
be fully discharged (through normal use) every
6 months approximately. Then recharge the
shaver to full capacity. Do not expose the
shaver to temperatures higher than 50 °C for
extended periods of time.
Replacing the shaving parts
To maintain 100% shaving performance,
replace your foil and cutter block every 18
months or when worn. Change both parts at
the same time for a closer shave with less skin
irritation.
(Shaver foil and cutter block: part no. 5000/
6000)
Environmental notice
This appliance is provided with nickel-hydride
rechargeable batteries. To protect the envi-
ronment, do not dispose of the appliance in
the household waste at the end of its useful
life. Open the housing as shown on page 31,
remove and dispose of the batteries at your
retail store or at appropriate collection sites
according to national or local regulations.
Subject to change without notice.
This product conforms to the EMC-
Directive 89/336/EEC and to the Low
Voltage Regulation 73/23 EEC.
Electric specifications see printing on the
special cord set.
Flex_XP_5775/70_MN Seite 7 Mittwoch, 12. November 2003 3:52 15
To Next Page
Loading...
Need help?
General
