11
• In between, shake or blow off the hair from the clipper. If too much hair is
caught in the distance comb, remove it.
• To control your progress during clipping, regularly comb the hair in the
style desired.
Hair cutting
Hair cutting with hair clipping comb
• Place the hair clipping comb (1a/1b) on the appliance with the appliance
turned off.
• Press the length selector (3) and slide the hair comb up to your desired
hair length. Possible length settings (mm):
Long hair clipping comb (1a) = 14 / 17 / 20 / 23 / 26 / 29 / 32 / 35
Short hair clipping comb (1b) = 3 / 6 / 9 / 12 / 15 / 18 / 21 / 24
• Turn the appliance on by pressing the on/off switch (4) and cut hair to the
desired length.
Hair cutting without hair clipping comb
• Remove the clipping comb.
• To start clipping, turn the appliance on by pressing the on/off switch (4).
• Move the cutting system only in a parallel position to the skin (A, cutting
hair). Slowly and carefully move the appliance against the direction of hair
growth.
• Only when trimming contours the cutting system should be positioned
vertically (B, trimming).
• Make sure you do not tilt the appliance while it is touching the skin (C).
• Avoid jerky movements while cutting.
Cleaning
Regular cleaning ensures better trimming performance.
Cleaning with the brush
• Switch off the appliance. Open the cutting system by pressing with the
thumb against the trimmer from the front side. It opens by ca. 45°.
• Using the brush clean the trimmers and the space behind the trimmer
(inside the housing).
Cleaning with water
• Switch off the appliance and rinse the head and the trimmer under warm
running water until all residues have been removed. You can also rinse the
opened cutting system.
96830133_HC5050_MN_S4-66.indd 1196830133_HC5050_MN_S4-66.indd 11 15.05.14 08:2315.05.14 08:23
CSS APPROVED Effective Date 21May2014 GMT - Printed 30Sep2015 Page 11 of 66
To Next Page
Loading...
