NOTE: If the probe has been properly inserted into the ear canal during the measurement, a long beep will sound to signal
the completed measurement.
If the probe has NOT been constantly placed in a stable position in the ear canal, a sequence of short beeps will sound, the
ExacTemp light will go out and the display will show an error message (POS = position error).
See «Errors and troubleshooting» section for more information
The confirmation beep indicates that an accurate temperature measurement has been taken. The result is shown on the
display
For the next measurement, press Eject button to remove and discard used lens filter, and put on a new, clean lens
filter.
The Braun ThermoScan ear thermometer turns off automatically after 60 seconds of inactivity.
The thermometer can also be turned off by pressing and holding down the Power button .
The display will briefly flash OFF and it will go blank
To Next Page
Loading...
