14
Ergonomic certification
This unit, assessed and
certified by an Ergonomics
Certifying Institute has
been ergonomically
designed, for effortless
ironing and excellent
results fulfilling the
ergonomic requirements
belonging to Polytechnical, Biomedical,
Psychosocial (usability) and Human
Centered Design Process area.
Real users have been actively involved
in all phases of product design and in
testing process to get a more satisfying
experience.
Follow the below recommendations, for an
effortless and more comfortable ironing
experience:
z
Before starting your ironing session, it
is recommendable to self-adjust your
ironing board in order to reduce shoulders
bad postures. The ideal position should
allow a 90° angle for your elbow so that
your shoulders and back can freely move.
z
It is mandatory emptying the water tank
before transporting the unit and making
sure not to overly bend your back while
lifting it.
(E) Auto Off
This function is activated if after 10 minutes
there has been no steam emission.
z
When the iron is in the auto-off mode,
the iron LED (1b) and the icon related to
the selected setting start flashing.
z
To continue ironing, press any button and
wait until the related icon for the setting
is permanently on.
z
After additional 10 minutes without
steam emission, the iron and the steam
station turn off.
(F) Descaling
Never open or touch the descaling valve
(13) when the appliance is hot and/or
plugged in.
Do not use any chemicals, additives or
descaler to rinse the boiler.
When the system needs to be decalcified
the FastClean system icon (3) starts
flashing.
To perform the descaling take the following
steps:
z
Switch off (1) and unplug the appliance.
z
Empty the water tank.
z
Wait until the appliance has cooled down
(minimum 2.5 hours).
z
Place the appliance on the edge of the
sink and turn the descaling valve (13)
anticlockwise to open it. Let the water
flow into the sink.
z
Clean the descaling valve under running
water to remove the scale formations.
z
When no more water comes out of the
appliance screw the descaling valve
clockwise to close the boiler.
z
Plug in and switch on.
Note: If you use an installed in-house
permanent descaler, it is recommended to
descale the system after every 4 complete
tank refills or at least once per month.
Please note that in this case the FastClean
icon will not automatically turn on.
(G) After ironing
Care & Cleaning
After every ironing session remove and
empty the water tank.
z
Before cleaning, always make sure that
the appliance is switched off, unplugged
and has cooled down completely.
z
To clean the soleplate and the soft
material on the handle it is suggested to
use a damp cloth.
z
Never use chemicals, vinegar or scouring
pads (eg. sponges with coarse nylon
fabrics etc).
5712870083_SI 52xx _INT.indd 145712870083_SI 52xx _INT.indd 14 16.10.23 13:4016.10.23 13:40
To Next Page
Loading...
