Page 28
UP
Lift Operating Instructions
To Load Passenger:
1. Load passenger onto platform
facing outward and lock wheel-
chair brakes.
Note: Roll stops must be fully
unfolded (ramp position) until the
entire wheelchair has crossed the
roll stop. See Photos K and L.
2. Press red UP switch until platform
stops (reaches floor level). Re-
lease switch.
Handrail Switch: Slide knob out to
UP position.
Note: Roll stops must be UP and
roll stop latch must be fully en-
gaged before raising platform.
Platform will raise above ground
level approximately two inches
before latch engages fully.
approximately 2"
M N
P
O
To Next Page