11
Cleaning the shaver head
After shaving, unplug the appliance.
If necessary, remove the trimmer cap
and clean it with the brush.
In order to clean the shaver head, remove
the shaving foil frame (b).
To do so, press the release bars (c) on
the front and back and pull off. Carefully
tap the shaving foil frame on a flat surface.
Brush out the cutter block (d) as well as
the area below the cutter block.
The shaving foil is a very delicate part
that must not be cleaned with the brush.
We recommend that you put a drop of
light machine oil along the length of the
trimmer every 3 months.
Put the shaving foil frame back on and
snap it into place.
Replace the trimmer cap which also
serves as a protective cap.
Note: Do not use the shaver head with a
damaged shaving foil.
Replacing the shaving parts
The shaving foil and the cutter block are
precision parts that wear out with the
time. Have the shaving foil frame and the
cutter block replaced when you notice a
reduced shaving performance even after
cleaning the shaver head.
Please do not dispose of the
product in the household waste
at the end of its useful life.
Disposal can take place at a Braun
Service Centre or at appropriate
collection points provided in your
country.
Subject to change without notice.
99923878_SE3270_China.indd 1199923878_SE3270_China.indd 11 17.06.11 10:3717.06.11 10:37
To Next Page
Loading...
