4
Our products are designed to meet the highest
standards of quality, functionality and design.
We hope you enjoy your new Braun shaver.
Your Braun Syncro is supplied with a
Braun Clean&Charge (please see separate
use instructions).
Important
Only use the power supply cord set provided.
A damaged cord must be replaced immediately.
Description
1 Foil protection cap 6 Switch
2 Shaver foil 7 Display
3 Cutter block 8 Info key
4 Foil release button 9 Pilot light
5 Long hair trimmer 10 Shaver socket
Technical specifications:
•
Wattage via cord set: 7 W
•
Power supply via cord set:
100-240 V
2
/ 50 or 60 Hz (automatic adaptation)
•
Shaver input voltage: 12-24 V
Charging the shaver
•
First charging: Using the power supply cord set,
connect the shaver to the mains with the switch on position
«0» and charge it for at least 4 hours
(plug might get warm).
•
Once the shaver is completely charged, shave without
the cord until fully discharged. Then recharge to full
capacity again (subsequent charges will take about
1 hour).
•
A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
•
Best environmental temperature range for charging is
15 °C to 35°C.
+35°C
+15°C
210
7570
English
5491453_S_S 4-74 Seite 4 Montag, 20. November 2000 8:28 08
To Next Page
Loading...
