Braun thermoscan PRO 4000 - Product Description

15
Product description
1. Probe cover
2. Probe
3. Probe cover detector/automatic «on»
4. Probe cover ejector
5. Display
6. «I/O» button (On/memory function)
7. «ExacTemp» light
8. Start button
9. Battery door
10. Protective cover
How to use your Braun ThermoScan
1.
To achieve accurate readings, make sure a new,
clean probe cover (1) is in place before each
measurement.
2.
When the probe cover is in place, the thermometer
turns on automatically. Wait for the ready signal
beep.
3.
Fit the probe snuggly into the ear canal, then push
the start button (8).
If the probe has been fitted correctly into the ear
canal during the complete measuring process, a long
beep will signal the end of the measuring process.
You can be assured to have taken an accurate
temperature reading. The result is shown on the
display (5).
If you take the temperature of another person, the
«ExacTemp» light (7) will be of help. It flashes during
the measuring process as long as the probe is
correctly positioned, and lights up continuously
when an accurate reading has been taken.
4.
If the probe has not been positioned correctly in
the ear canal or was moved during the measuring
process, a sequence of short beeps will sound, the
«ExacTemp» light will go out and the display will
show an error message («POS» = position error).
start
ThermoScan
E
x
a
c
T
e
n
start
6021220_Pro4000_S4-76 Seite 15 Dienstag, 15. März 2005 3:03 15