13
The power bars show an unfamiliar pattern of one
red LED shining along with individual white LEDs.
Device error. Device will not operate.
Remove and replace the power supply connection.
If error persists, contact a Braun Service Centre for
repair.
All white LEDs flash. End of product lifetime. Maximum number of
flashes (120,000) has been reached.
The device is broken, cracked or appears
defective.
DO NOT USE if the device, the mains cord or the
power supply is damaged. If you are in any doubt
about the safety or suspect it is damaged in any
way, you must not use it.
Warranty
1 year limited warranty
Braun warrants this device to be free of defects in material and workmanship for a period of one year from
the date of original purchase.
If the device exhibits such a defect, Braun will, at its option, either repair or replace it for the consumer
without charge.
Please call 1-800-Braun 11 (800-272-8611) to be referred to the authorized Braun Service Center closest
to you.
This warranty does not cover damage resulting from accident, misuse, abuse, dirt, water, tampering,
unreasonable use, servicing performed or attempted by unauthorized service agencies or failure to
provide reasonable and necessary maintenance.
ALL IMPLIED WARRANTIES INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS
FOR ANY PARTICULAR PURPOSE ARE LIMITED IN DURATION TO 1 YEAR FROM DATE OF ORIGINAL
PURCHASE. IN NO EVENT WILL BRAUN INC. BE RESPONSIBLE FOR CONSEQUENTIAL DAMAGES
RESULTING FROM THE USE OF THIS PRODUCT.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other legal rights which vary from state
to state.
Labels and Symbols
The device is marked with the following symbols:
Type BF Applied Part
Class II equipment
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
90794569_BD5001-BD5008_UK_S4-14.indd 1390794569_BD5001-BD5008_UK_S4-14.indd 13 08.12.15 13:1508.12.15 13:15
CSS APPROVED Effective Date 15Dec2015 GMT - Printed 31Mar2016 Page 13 of 14
To Next Page
Loading...
