GLAM Wi-Fi Thermostat
Mod. 93003112
Read carefully and keep the manual.
Description of monitor and stationary unit keys
Menù
Date/Time
ON/OFF
Key +
Key-
Backlight
Stand by wake up
Red led on:
xed unit on
Green led on:
Heating on
Green led ashing fast:
waiting for connection
Blue led slow ashing:
Wi-Fi connection problem
Blue led on:
connected to Wi-Fi
ON/OFF
NB: In order to maximize energy savings, the display if no key is pressed, will go into standby,
highlighted by turning off the backlight.
In order to access the controls again, press the key located on the side of the device (Backlight/
Stand by wake up).
When installing, keep in mind that in order for the thermostat to work in Wi-Fi and be controlled
by a smart phone, it must receive a good signal from the Wi-Fi network (metal walls or very thick
walls can reduce the signal). The stationary unit needs 220V power supply.
1) Separate the back docking plate from the thermostat and insert 2 alkaline batteries (1.5V AAA)
into one of the slots, paying attention to polarity. NB: It is possible to insert 2 more batteries in the
second slot to double the operating time of the device.
2) Reposition the docking plate and make sure the thermostat is turned off. Press and hold the ON/
OFF button until the display shows OFF.
To Next Page
Need help?
General