Bray Flow-Tek Triad Series - 6.2 Unpacked Valves; 6.3 Moving Valves

TRIAD SERIES 3-PIECE BALL VALVE
Installation, Operation, and Maintenance Manual
 of ©  BRAY INTERNATIONAL INC ALL RIGHTS RESERVED BRAYCOM The Information
contained herein shall not be copied transferred conveyed or displayed in any manner that would
violate its proprietary nature without the express written permission of Bray International Inc
While unpacking the valve check the packing list against the
materials received Lists describing the valve and accessories
are included in each shipping container and General Assembly
drawing as applicable
WARNING
Never lift the valve or valve package by the actuator
positioner limit switch or their piping When lifting a valve be
aware that the center of gravity may be above the lifting point
Therefore support must be given to prevent the valve from
rotating Failure to do so can cause serious injury to personnel
and damage to the valve and nearby equipment
Contact your shipper immediately if there is shipping damage
Should any problem arise call your Bray representative
WARNING
A potential hazard exists with handling valves Failure to
handle valves properly may cause a valve to shift slip or fall
causing serious injury or death andor equipment damage
 Moving Valves
Moving crated packed or palleted products must be done in a
safe manner using appropriate lifting equipment (ie forklift
hand truck pallet jack etc)
Lifting of products should be done using lifting points and in the
center of gravity position as marked in observance of existing
carrying limits
CAUTION
Product is shipped in protected position and must be
transported in such as way as to avoid damage during
movement
For handling andor lifting the lifting equipment (fasteners
hooks etc) must be sized and selected while considering the
product weight indicated in our packing list andor delivery note
Lifting and handling must be performed only by qualified
personnel
Fasteners must be protected by plastic covers in sharp corner
areas
Caution must be taken during handling to avoid this equipment
passing over workers or over any other place where a possible
fall could cause injury or damage In all cases local safety
regulations must be respected