Designed and assembled in the United States of America.
Breas Medical, Inc. N. Billerica, MA 01862
PowerShell®, Z1® and the HDM logo are registered trademarks of Breas Medical, Inc. N. Billerica, MA 01862, USA.
US Patent Pending. © Copyright 2014-2018, Breas Medical AB. All rights reserved.
PowerShell Getting Started v1 08152018
40-0012 Rev. C
PowerShell
®
with Extended Life Battery
Getting Started Guide
1. With both the Z1 and the battery fully
inserted into the PowerShell, plug the power
supply (AC to DC Adapter) as shown in the
wall outlet. The Z1 must be in standby mode
(display reads ) to charge the battery.
Charging the battery.
2. The battery status indicator on the Z1
( ) will flash when the battery is charging.
The number of solid bars indicates the
current level of charge. The battery charging
is complete when the 4th bar stops flashing.
x
The Z1 can be removed from the PowerShell by pressing the two ( ) icons on the sides of the
PowerShell and sliding the Z1 out. The battery can be removed from the PowerShell by the two
blue buttons on the battery shuttle and sliding the battery out.
NOTE: If the PowerShell does not appear to be charging, disconnect Z1, battery, and power supply
and reassemble. Make sure you hear the components click together and see that the DC plug (silver
cylinder in the bottom of PowerShell) goes into the hole in the CPAP and then reattempt to charge the
PowerShell.
If you encounter other problems consult the Z1 User Guide or contact the Support Center
toll-free at 1-855-436-8724.
To Next Page
General
