Recalibration
How do I reset or rebalance my board?
The Breezeboard PRO from time to time needs a reset, this is easy to do:
1. Charge the Breezeboard PRO for two hours.
(The charger has a red light on it which illuminates when plugged in, this red light
will turn to green when fully charged.) Then unplug the charger.
2. Turn off the Breezeboard PRO and make sure the tops of both sides of the
boards are level. If its working ne both lights should light up quickly and then
reduce to just one green light on the top of the board.
3. Turn off the board.
4. Hold down the “on” button for 30 seconds. The blue lights should come on
under the Breezeboard PRO and start ashing. Let them continue for 30 seconds.
5. Turn off the Breezeboard PRO.
FINALLY – Turn it back on again two green lights then one on the top?
YOU’RE GOOD TO GO! HAPPY BREEZEBOARDING
Not Green? Email: customerservices@breezeboardpro.com
How do I use the Keyfob?
The remote control is the key fob in the box. Although this has four buttons it’s
used for just turning the board on and off remotely. Alternatively, if you prefer you
can use the silver on/off button on the side of the Breezeboard PRO. The other
buttons are redundant and have no functionality.
TO PAIR THE KEYFOB TO YOUR BOARD:
When the board is turned on, turn it off with your keyfob, this will pair it to your
board. From then on you will be able to turn it on and off remotely.
DO NOT TURN THE BOARD OFF WITH KEY FOB WHEN BOARD IS MOUNTED.
www.breezeboardpro.com
7
To Next Page
Loading...
Need help?
General
