General condition
1. Check for any damage, wear or leaks on all the hose and fittings
Checking the fuel level
Warning! Make sure area is well ventilated
Warning! Keep fuel away from open flames and heat sources
Adding Engine Oil
Attention! Only use the approved
oil SAE 10W40
1. Clean area of the oil fill cap
2. Unscrew fill cap and top up
3. Fit the filler cap
4. Run the engine for approx. 1
minute and recheck the oil level
1. Switch off the engine by moving
the throttle run lever to the stop
position.
2. Clean area around the filling cap
3. Unscrew the filling cap
4. Check fuel level, add if
necessary
Note: Tank capacity 5 L
5. Screw fuel cap back on
6. Cleanup any spilt fuel
Engine Oil
Attention! The engine must be
Switched off.
Warning! Oil level will not read
correctly when the engine is warm
1. Put the machine on level
ground.
2. Clean area around the dipstick.
3. Unscrew dipstick and pull it out
4. Clean dipstick.
5. Replace dipstick and tighten.
6. Unscrew dipstick pull it out and
check oil level
7. The oil level should be between
the MIN-MAX
Put the dipstick back
To Next Page
Loading...