9
8. Press MEM/ or CH/ to set the hours for the current time.
9. Press AL/SET to switch to the next setting.
10. Press MEM/ or CH/ to set minutes for the current time.
11. Press AL/SET to switch to the next setting.
12. Press MEM/ or CH/ to switch between ON or OF to enable or disable
24 hour measurement data storage.
13. Press AL/SET to save and exit settings mode. If there is no operation for
20 seconds, the existing setting will be saved and the device returns to
normal display mode.
NOTE!
When choosing ON for 24 hour measurement data storage all stored MIN/
MAX values for temperature and humidity will be deleted daily at 0:00
h! When choosing OFF the data will be stored indefinitely until a battery
change is required.
Alarm time setting
To set the alarm time, proceed as follows:
1. In normal time mode press the AL/SET touch control (10b) once to switch
to alarm time display.
2. Press the AL/SET for approx. 3 seconds to enter the alarm time settings
mode. Hours will flash.
2. Press the MEM/ or CH/ touch control (10a/10c) to set the desired
hours.
3. Press the AL/SET to switch to the next setting.
4. Press the MEM/ or CH/ touch control (10a/10c) to set the desired
minutes.
5. Press the AL/SET to switch to the next setting.
6. Press the MEM/ or CH/ touch control (10a/10c) to switch between ON
or OFF to enable or disable the alarm.
7. Press the AL/SET to save and exit settings mode. The symbol will be
displayed when the alarm was enabled.
8. Press SNOOZE/LIGHT button (16) when alarm sounds to interrupt the
alarm. The symbol will flash and the alarm will sound again after 5
minutes. Press the AL/SET to deactivate the alarm until next day.
Temperature and humidity
2. Once the batteries are installed the main unit will start displaying the interior
measurement information. The main unit will display the information from
the outdoor sensor for the first time approximately 3-4 minutes after the
power supply was established.
Manual_7007401_RC-Hygrometer_en-de_BRESSER_v082019a.indd 9 26.08.2019 08:12:25
To Next Page
Loading...
