EN-2020-03 3 | 7
Introduction
This user guide explains how to disassemble and assemble the heating elements in our Pro-
Series Brewing Systems. Disassembly of the heating elements will at some point be
necessary. You may need to replace the silicone gaskets or replace a faulty element with a
new one. This guide will help you through it.
As the work described in this user guide is
electrical, it needs to be carried out by skilled
technician that can ensure the quality and
electrical safety of the work done. This is due
to the potential risk of electric shock or
overheating in connections that might cause a
Performing this type of work will require the heat shrink tube to be replaced. Ensure that
you have heat shrink tube at hand before starting this type of work. Recommended size of
heat shrink tube is 10mm (3/8’’) with a 3x shrink factor.
You need
• Sharp knife
• Wrench or spanner
• Heat gun
• Heat shrink tube
• Allen key 1.5mm
• New heating element or gasket depending on intended work to be performed
Before starting, make sure that all power input cables are detached so that the system is
disconnected from the power grid. Also ensure that the heating elements are not hot.
To Next Page
