2022 Owner’s Manual Eagle 8 BRIG ltd
41
If you need to drop the anchor by electric windlass:
1.Set the windlass circuit breaker (8) to the OFF position (battery isolation switch panel (Fig.2b, (28)).
To do this,
press the button (8a). In this case, the lever switch (8b) will move to the down position.
2.Open the bow anchor hatch (11). By means of special handle (supplied) close the clutch nut (3).
3.Disengage safety pin (6) from chain.
4.Set the windlass circuit breaker (8) to the ON position. To do this, move the lever switch (8b) to the upper
position by pressing it from the bottom up
until it locks.
5.By means of anchor windlass "DOWN" switch (9) (steering console, dashboard) drop the anchor.
You can also use the button (9a) to drop the anchor.
6.After anchoring the boat, close the bow anchor hatch (11).
If you need to raise the anchor by electric windlass:
1.Set the windlass circuit breaker (8) to the OFF position (battery isolation switch panel (Fig.2b, (28)).
To do this,
press the button (8a). In this case, the lever switch (8b) will move to the down position.
2.Open the bow anchor hatch (11). By means of special handle close the clutch nut (3).
3.Check that the safety pin (6) is detached from chain.
4.Set windlass circuit breaker and battery disconnectors to the ON position.
5.By means of anchor windlass "UP" switch (9) begin to raise the anchor.
You can also use the button (9a) to raise the anchor.
6. When the anchor will begin to crawl on a roller, stop windlass electric motor in order to make sure that the
anchor is not swinging and have occupied correct position. CHECK, THAT THE ANCHOR OCCUPIED CORRECT
POSITION (Fig. 16).
7.Continue to stow the anchor, until it will be fixed on a rollers.
8.Switch OFF the windlass circuit breaker (8).
9.Hook safety pin (6) to chain. Close the bow anchor hatch (11).
In the event of overloads in the anchor system, the circuit breaker (8) can set itself (automatically) to the OFF
position. In this case, you can turn ON the circuit breaker only after eliminating the reason for turning it off.
To Next Page
Loading...
