2022 Owner’s Manual Eagle 8 BRIG ltd
58
Fig.24
1 – console cover
2 – stern seat cover
3 – snap fastener
4 – buckle and belt
OVERALL COVER.
You can use a overall cover for your boat (Fig.25). The overall cover is not available for a boat with a T-Top and for a boat
without a stern mast. The motor should be raised with trim.
Begin installing the overall cover at the bow of the boat and unfolding it towards the stern. Make sure the overall cover is
laid out symmetrically to the boat tube.
Tighten the rope (2) evenly on the left and right sides. Tie the rope securely.
Secure the upper and lower belts (3) with buckles (4).
Contact your BRIG dealer if you need advice.
To Next Page
Loading...
