2022 Owner’s Manual Eagle 8 BRIG ltd
7
IDENTIFICATION PLATES.
It is fundamental for the plates to be aboard the boat, since they are only form of recognition and identification.
Without them the boat does not comply with the legislation in effect. The plates must never be removed. Any
tampering or removal not authorised by the manufacturer is the full responsibility of the owner.
Builder’s plate. Installed on the hull of the boat near the stern seat.
1
2
3
4
5
6
7
1 - Manufacturer’s name and contact address of the manufacturer
2 - Model name
3 - Maximum recommended load (including mass of the persons and cargo onboard, but excluding mass of the
max motor(s), the mass of the contents of fixed fuel and water tanks when full)
4 - Maximum mass of the outboard including controls and batteries
5 - CE mark
6 - Design Categories according to Directive 2013/53/EU
7 - Maximum number of persons (75 kg each) for C or B Design Categories
8 - Maximum outboard power rating (in kW)
9 - Nominal pressure for each inflatable buoyancy chambers
To Next Page
Loading...
