BRIGHTWIN Intelligent mA V SIGNAL GENERATOR BRT LB02G
www.brightwinelectronics.com
info@brightwinelectronics.com
Intelligent Analog 0-22mA 0-±10V Signal Generator
BRT LB02G
Technical Parameters
0-22mA adjustable, support fast output. Default 0-20mA, switchable
0.05mA, can be calibrated, 0.5% TYP.
Current sampling resistance
10-500Ω, can be short-circuit.
-10V - +10VDC adjustable, support fast output. Default 0-10V, switchable
0.03V, can be calibrated, 0.5% TYP.
driving current <20mA, max. 100mA, have short-circuit protection
15-30V external power supply via wiring terminals; 5V, 0.5A micro-USB, etc.
4 digits, two decimal points
Current/volt. value display; 0-100% percentage display; 0-50.0Hz display, etc.
One turn: 20 x pulses, precision encoder.
External 15-30V power supply: about 4W; Micro USB 5V power supply: 0.5A/0.8A
L x W x H: 100x60x20mm, Knob height: 15mm; 105g
80% R.O. non-condensation
Operating power supply input 24V +
Operating power supply terminal 24VDC
Operating power supply GND-
Sink current mode 24V external
power supply input
Sink current signal output: AI+ is connecte
to external 24V+, output signal via AIO to
contorl exernal current from 24V.
Source current signal output: AIO is signal
output +, GND is the common GND.
Voltage signal output: AVO is volt signal
output+, GND is the common GND.
Current/volt. signal output GND-
[Mode] button: Press once, switch between adjusting current output mode and adjusting voltage output mode
[Battery SW ON/OFF]: Battery power supply switching ON/OFF.
[Voltage] indicator: the signal generator is in voltage signal output and adjusting mode, the voltage indicator is ON.
[Current] indicator: the signal generator is in current signal output and adjusting mode, the current indicator is ON.
[MicroUSB-5V]: USB Port power supply recommended 5V 0.5A, DO NOT use quicker charger or higher than 2A power
supply. * Battery recharging time recommended 4-5 hours based on power adapter used.
Steady green
(Connect Micro USB)
To Next Page
Need help?
General
