24
Using the Versa-Tether
Installation: Versa-Tether
®
Consult your vehicle’s owner’s manual for
approved tether-anchorage locations.
Locate the tether on rear of restraint and
place up and over seat back while securing
restraint.
Secure child restraint by a seat-belt or LATCH
system.
Press and hold tilt-lock adjuster, then pull to
fully extend tether strap into a "V" shape.
Locate hook on strap and loosely attach
tether to an approved anchor point.
See figure A for forward-
facing installation.
See figures B and C for rear-facing
installation.
NOTE: Rear-facing installation may also require
use of Tether Connector Strap, as described on
page 25.
Pull Versa-Tether strap to remove all slack.
Roll up excess webbing and store in tether
pouch.
Verify there is tension in Versa-Tether strap
and that child restraint is properly secured.
The restraint is secure when it cannot be
moved front-to-back or side-to-side more
than 1 inch (2.5 cm.) at belt path. If restraint
is not secure, repeat procedure or use an
alternate seating location.
1�
2�
3�
4�
5�
•
•
6�
7�
A
B
C
To Next Page
Loading...
