Brivis Contour Series - Using the Timer Function; Timer for Auto Shutoff; Timer for Auto Turn On; Programming Timer Settings

Using the Timer.
If you wish to drift off to sleep under a gentle breeze, you can.
Whenever the Cooler is ON, you can pre-set a time for the Timer to turn the Cooler OFF.
Or, if you are out for the day and you want the Cooler to come ON and pre-cool the house
before you return, you can.
Whenever the Cooler is turned OFF, you can select a time for the Timer to turn it ON
automatically.
Just remember that, when the Timer turns the Cooler ON, it will operate with the same
settings it had the last time it was ON.
So, if you want the settings to be different, just turn the cooler ON, change the settings and
turn it OFF again. Then you can begin to program the Timer.
First use the MODE control key [4] to select "Cooler" [4a].
Then press the PROG key [5] and the "Set" Time [11] and the word "Program" [5a] will
flash.
Now you will notice that one of the Control Keys [8] will be either the "On Time" or the "Off
Time" key .
If the Cooler is OFF, press that key [8] to set the "On Time". That is, the time you want it to
come on.
Now use the ROTARY DIAL [2] to set the "On Time".
If the Cooler is ON however, press that key [8] to set the "Off Time". That is, the time at
which you would like it to turn off.