X7-4-Install-IG100 Installation Guide
Brocade
®
X7-4 Director Hardware Installation Guide
tempShow
Use the tempShow command to display temperature readings of blade temperature sensors. The command displays the
following information:
•
Sensor ID (an index number)
•
Slot number
•
Sensor index (when command issued with the --detail option)
•
Sensor state (OK or absent)
•
Temperature in both Centigrade and Fahrenheit
The following is an example of tempShow output:
chassisX7-4:admin> tempshow
Sensor Slot Sensor State Centigrade Fahrenheit
ID Index
===================================================================
1 3 0 Ok 29 84
2 3 1 Ok 47 116
3 3 2 Ok 43 109
4 4 0 Ok 34 93
5 4 1 Ok 53 127
6 1 0 Ok 36 96
7 1 1 Ok 39 102
8 1 2 Ok 33 91
9 1 3 Ok 41 105
10 2 0 Ok 43 109
11 2 1 Ok 44 111
12 2 2 Ok 41 105
13 2 3 Ok 45 113
14 5 0 Ok 31 87
15 5 1 Ok 45 113
16 5 2 Ok 48 118
17 6 0 Ok 31 87
18 6 1 Ok 45 113
19 6 2 Ok 45 113
20 7 0 Ok 29 84
21 7 1 Ok 44 111
22 7 2 Ok 43 109
23 8 0 Ok 30 86
24 8 1 Ok 45 113
25 8 2 Ok 43 109
Note the following facts about this output:
•
The absent state simply reflects that the blade slot is empty.
•
The sensor index is mainly for support use.
•
Multiple sensors are commonly averaged to determine thresholds used for managing fan speeds or for determining a
high temperature condition that may require that the blade be shut off.
X7-4-Install-IG100
117
To Next Page
Loading...