Broadcom Brocade X7-4 Director - Cable Management Fingers; Cable Management Fingers Overview; Time and Items Required for Removal and Replacement; Removing the Cable Management Finger Assembly

X7-4-Install-IG100 Installation Guide Brocade
®
X7-4 Director Hardware Installation Guide
Cable Management Fingers
Cable Management Fingers Overview
The X7-4 Director comes equipped with two vertical cable management finger assemblies. It can continue to operate
during the replacement of the cable management fingers. Due to the horizontal orientation of the blades in the device, the
finger assemblies are attached to the uprights of the mounting rack.
Time and Items Required for Removal and Replacement
The replacement procedure for the cable management fingers takes less than five minutes. A No. 1 Phillips screwdriver is
required.
Removing the Cable Management Finger Assembly
Complete the following steps to remove the cable management finger assemblies from rack uprights. Cable management
finger assemblies are shown installed in the following figure.
X7-4-Install-IG100
184
Broadcom